KOREMA® is always available to answer specific questions concerning installation procedures and torque requirements. Bolted connections are the preferred method of installation for large section circular and rectangular expansion joints.
Flange dimensions and correct bolt spacing are essential for a good seal. After assembly, check the expansion joint for correct position on the frame. Use a torque wrench to check bolt tightness. Rechecking after one or two days is recommended, as the fabric is compressed when first installed and bolts can loosen.
For any further queries feel free to contact the KOREMA® engineering department. They will be glad to be at your service.
General instructions for installation
Use the possibility to print the handling-instructions as PDF: